Fit- Slash Stampede Rustler Hoss 4x4
Notes:
The upper hinge pin hole of the rear axle carriers cannot be used (not a stock location for the Slash 4x4) due to strengthening designs that reduce the clearance around the rear axle.
Notes:
These parts are not interchangeable with stock or aftermarket steering blocks / caster blocks. Running any part of this system with other stock or aftermarket steering blocks or caster blocks may void the RPM warranty.
They eliminated the slop in the suspension system, tightening the tolerances around the hinge pins, reduced the fore and aft movement of the A-arms at both the inner hinge pin and at the axle carriers by better than 90% and improved the durability dramatically (they’re made by RPM, enough said). As a bonus, they cut 6.5 grams of weight off of each A-arm! That’s a total loss of just under one ounce of weight simply by replacing your stock A-arms with the RPM versions!
RPM Rear Bearing Carrier Set, The stock version simply can’t handle Short Course carnage like RPM products can. The RPM version is 100% stock geometry-perfect, but with a few tweaks to improve durability significantly. A ring surrounds the bearing bores, providing additional rigidity while a redesigned camber rod mounting boss helps disperse impact energy more evenly throughout the length of the carrier’s arm. Additionally, the bearing bores in these bearing carriers are designed to hold the bearings tight, meaning absolutely no bearing slop in the bearing bores! RPM also reduced the end play of the axles by approximately 1/64”, keeping your rear end tracking perfectly like it’s supposed to.